|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
06-01-2017, 06:05 PM
|
#1 | ||
|
Starter Motor
Join Date: Jun 2011
Location: Bairnsdale
Posts: 17
|
Hi. I have an old 6303-B Clevo crank that has been stored for a few years. it has surface rust but other than that no damage. I pulled the block down with intentions of a rebuild many moons ago but it didn't happen. Question i am asking....would the cost of refirbishing it be more than replacement cost?
|
||
|
|
|
06-01-2017, 07:48 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Jun 2005
Posts: 5,193
|
I would not bother refurbishing any crank.
Buy a stroker crank and bask in the seemingly endless mountains of torque. |
||
|
|
|
|
06-01-2017, 09:06 PM
|
#3 | ||
|
Starter Motor
Join Date: Jun 2011
Location: Bairnsdale
Posts: 17
|
Hi Stefan, after a bit of research i have come to the same conclusion. Thanks for the reply brother.
|
||
|
|
|
Cranky
Linear Mode
