Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > General Topics > The Pub

The Pub For General Automotive Related Talk

Reply
 
Thread Tools Display Modes
Old 14-02-2008, 09:12 PM   #1
Alan D
Starter Motor
 
Join Date: Aug 2006
Posts: 2
Default Territory Auxilliary Battery

I want to charge a battery in my caravan from the normal start battery in my car and am hoping that someone can advise the best way to run the cable from the battery to the anderson plug on the towbar. Any advice would be appreciated. Alan

Alan D is offline   Reply With Quote Multi-Quote with this Post
Old 14-02-2008, 09:25 PM   #2
Green X
FF.Com.Au Hardcore
 
Join Date: Aug 2006
Location: WA, Perth/ Pilbara
Posts: 2,473
Default

I take it this will be done wile the car is running yes?

The quickest way is just have it running underneath the car hugging the chassis, A low voltage Cut out devise or solenoid would also be a good idea to stop your main battery being run down if the car is switched off.
__________________
FPV GS ute 5.0 S/C
Twin 3-inch, pacemaker headers
Green X is offline   Reply With Quote Multi-Quote with this Post
Old 14-02-2008, 09:29 PM   #3
aquahead2001
FF.Com.Au Hardcore
 
aquahead2001's Avatar
 
Join Date: Jun 2005
Posts: 1,301
Default

Alan, I suggest you look at one of those dual battery charging arrangements that the 4WD guys use as a start. To run the cable down the back will a lot of fun, knowing what its like to go the inside route, see if there is a way to go underneath the car.

Inside, you have to pull off all the plastics on the driver's side in the rear just to follow the existing loom. Also there's not a lot of room at the bottom of the "B" pillar, and I couldn't figue out how to remove the plastics there. So I ended us poking a coat hanger through a few times until the 2 core cable I used for the electric brakes could be squeezed through.

If you follow the loom through to the back of the car, you see where it pokes through the body under the bumper. Just need a few cable ties to secure it, then re-assemble all the plastics making sure they all go back where they belong to avoid future rattles & squeeks.

I fitted electric brakes so know how much fun that was...

Enjoy!
aquahead2001 is offline   Reply With Quote Multi-Quote with this Post
Old 14-02-2008, 10:21 PM   #4
Alan D
Starter Motor
 
Join Date: Aug 2006
Posts: 2
Default

Thanks for the advice. Looks like it will be trial and error but would prefer to keep the wiring inside the car
Alan D is offline   Reply With Quote Multi-Quote with this Post
Reply


Forum Jump


All times are GMT +11. The time now is 11:10 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL